Skip to content

Manufacturing & Distribution

Standardise AHU parts, then stock spares

  • Manufacturing & Distribution
  • 1 min read

Twelve air handlers bought in three tenders can arrive with nine motor frames, five belt sections and filters in seven face sizes.

Each was a reasonable choice by the vendor who sized it. Together they turn the spares list into a small warehouse, and a technician on the night shift opens the store to find that the belt for AHU-07 is the one size nobody kept.

The cheaper fix happens at specification. Write a short standardization schedule into the AHU datasheets before tender and hold every vendor to it:

  1. Motors from a limited set of IEC frame sizes and one efficiency class, or EC fans of one family where the project uses fan walls.
  2. Filters in standard face sizes such as 592 × 592 and 592 × 287 mm, so one stock covers every unit.
  3. Temperature, humidity and pressure sensors of one make, range and signal type, so a spare fits any AHU and one calibration procedure covers them all.
  4. Belts, bearings, gaskets and door handles from the same few part numbers.

The price is some loss of freedom. A vendor may have to fit a motor one size up, or a filter bank with a little more frame. Over the life of a plant that small cost usually buys a shorter spares list and faster repairs.

AeroSano units are engineered from the project's airflow schedule, and that schedule is where the standard sizes get fixed.

Related

More on this subject