Skip to content

Life Sciences

Hot or ambient distribution for PW and WFI

  • Life Sciences
  • 1 min read

Water held hot in a distribution loop sanitizes itself every minute of the day, and it pays for that in energy and in rouge.

Choosing between a hot loop and an ambient loop with periodic sanitization is one of the early decisions on a PW or WFI system, and it is hard to reverse once the pipe is welded.

A hot loop runs continuously at a temperature where microbes do not grow, commonly around 70–80 °C for WFI. Microbial control is close to automatic. The costs sit elsewhere. Heat is lost along every metre of pipe. Users that cannot take water that hot each need a sub-cooler, a small heat exchanger that grows biofilm unless it is drained and sanitized with the loop. And stainless steel in hot, high-purity water rouges faster, so derouging goes on the maintenance calendar.

An ambient loop runs near room temperature with periodic sanitization: hot water on a timed cycle, or ozone dosed into the tank and destroyed by UV before the users. Energy is lower and user points need no coolers. In exchange, the sanitization cycle becomes a validated operation, and sampling has to show the loop stays in control between cycles.

Water quality, the number of hot users and the energy price all move the answer. Humiley fixes the circulation temperature in the design basis before the P&ID is issued.

Which way did your last WFI loop go, and would you choose it again?

Industries

Related

More on this subject

Knowledge management in ICH Q10, in plain terms

ICH Q10 names knowledge management as one of two enablers of the pharmaceutical quality system: a systematic approach to acquiring, analysing, storing and disseminating information about products, processes and components. In a technology transfer, that means handing over the reason behind each parameter, along with the batch record.

InsightRead

Maintenance that keeps the validated state

A filter changed on night shift without a leak test turns maintenance into a deviation. GMP maintenance works from criticality bands built on the asset register, planned and corrective work in one system, risk-based requalification and calibration, and 24/7 response across Southeast Asia under a maintenance agreement.

InsightRead

Pure steam quality is three tests, not one

EN 285 checks pure steam for dryness (at least 0.95, or 0.90 for metal loads), non-condensable gases (no more than 3.5%) and superheat (no more than 25 K). Each fails for a different piping cause: trapping and insulation, degassing and air ingress, or a large pressure drop near the point of use.

InsightRead