Skip to content

Engineering Solution & Consultancy

Knowledge management in ICH Q10, in plain terms

  • Engineering Solution & Consultancy
  • 1 min read

The engineer who knew why the granulator runs at that impeller speed retired last year. The batch record still gives the number.

When a tech transfer team asks whether the receiving site's granulator can run slower, nobody at the sending site can say what would break.

ICH Q10 names two enablers for the pharmaceutical quality system: knowledge management and quality risk management. Knowledge management gets a short section (1.6.1) and a one-sentence definition: a systematic approach to acquiring, analysing, storing and disseminating information related to products, manufacturing processes and components.

Its sources include development studies, technology transfer activities, process validation, manufacturing experience and change management.

On most sites the files exist. The weak point is the link from a parameter to the study or the change that set it, kept where a successor will look. On the engineering side we keep one design basis behind the drawing, the factory acceptance test and the maintenance task list five years later, so a setpoint can be traced back to it.

For a technology transfer that changes the package. The receiving site needs the master batch record, and it needs the reasons too: which parameters were explored and which were inherited, what failed in development, which change moved a limit.

Where does your site keep the "why" for a process parameter?

Industries

Related

More on this subject

Three APS runs across all shifts, and the HVAC has to hold still

Annex 1 initial validation of an aseptic process needs at least 3 consecutive successful simulations covering all working shifts, then periodic runs twice a year per process, line and shift. The cleanroom must hold its qualified state throughout. Agree an HVAC freeze date with QA, and list in advance which jobs are like-for-like and which need an impact assessment.

InsightRead

What ends the life of a HEPA filter

EU GMP Annex 1 (2022) asks for an integrity test of final filters at requalification and puts no age on the filter. A terminal HEPA is replaced when a leak cannot be repaired within site limits, when pressure drop reaches the manufacturer's final value, or after damage or wetting. On glass-fibre media, dust loading alone does not lower efficiency.

InsightRead