Skip to content

News

Preparing for a first site visit

  • News
  • 1 min read

Your first site visit will teach you more than a month of drawings, if you arrive knowing what you came to find.

Plenty of juniors walk a site behind a senior, take forty photos of things they cannot name the next day, and go home. A little preparation changes what the same two hours give. Tick these off:

  1. The latest revision of the drawings for the area is in hand, checked against the drawing register that morning.
  2. Site induction is booked and you have the PPE that site asks for. If the route crosses a clean area, ask about gowning first.
  3. In the bag: tape or laser measure, torch, camera, notebook, marker.
  4. Three things to find are written down, one of them above a ceiling and one inside a plant room.
  5. Notes are written up the same day, each photo tied to a drawing number and a location.

On site, take the wide shot before the close-up, with the equipment tag in frame, and measure what the drawing assumes. The beam that takes 200 mm out of a ceiling void is rarely on the HVAC section.

Our graduates learn through fundamentals and on-the-job training designed with lead engineers from the USA.

What did your first site visit show you that no drawing had?

Topics

Related

More on this subject