Skip to content

Life Sciences

Zero growth and the HVAC record around a media fill

  • Life Sciences
  • 1 min read

One contaminated unit in a media fill fails the aseptic process simulation under EU GMP Annex 1, where the target is zero growth.

The investigation looks at the process, the people and the environment. For the environment, the first evidence is the viable monitoring from the fill itself: active air samples, settle plates, contact plates, and glove and gown samples from the operators. The organism recovered from the failed unit is compared with what that monitoring found.

The HVAC and EMS record sits beside it. Differential pressures, Grade A airflow, continuous particle counts, temperature and humidity show whether the room held its qualified conditions through the fill. Stable, in-limit trends support a conclusion that the environment was not the source, though on their own they cannot settle it. A gap in those trends leaves a question the investigation has no data to close.

Three things are worth doing before the fill. Review the HVAC trends for the preceding days: a differential drifting down or a filter near its change point is easier to deal with then. Confirm that monitoring is logging, controller clocks are synchronized and backups ran. And agree with QA which HVAC events during the fill count as an interruption, while nobody yet knows the result.

We write the validation strategy alongside the design, so the monitoring behind this record is specified from the start.

More compliance notes from our team

Industries

Related

More on this subject

CTD Module 3 describes the plant you are building

The CTD has five modules, and Module 3 (Quality) records the process, its controls and often the facility, including room grades, water grades and the conditions behind hold times. After approval, changing them generally needs a variation. Draft Module 3 and the design basis from one table and send every change to both teams.

InsightRead

EU GMP Chapter 3 and 21 CFR 211 on HVAC

21 CFR 211.42 and 211.46 and EU GMP Chapter 3 ask for adequate ventilation, air control and filtration, but give no air change rate or pressure differential, and no filter class beyond HEPA for aseptic areas. Those come from Annex 1, FDA's 2004 aseptic guidance, ISO 14644 and the designer's justification, recorded in the design basis.

InsightRead