Skip to content

Life Sciences

Annex 1's scope reaches non-sterile plants

  • Life Sciences
  • 1 min read

The scope of EU GMP Annex 1 names creams, ointments and certain liquids. Many semi-solids plants have never opened it.

The 2022 revision is written for sterile products, but its scope section says some of its principles may be used for products that are not sterile, where control of microbial, particulate and endotoxin contamination still matters. It lists the contamination control strategy, premises design, cleanroom classification, qualification, monitoring and gowning among them, and gives examples: certain liquids, creams, ointments and low-bioburden biological intermediates.

"May be used" is permissive wording. Even so, an inspector who finds a cream filling room with no documented reasoning for its grade, its pressure regime or its monitoring points will ask what the site relied on instead. A plant that can point to its own CCS, built on the same logic, has an answer. "We are non-sterile" is only a scope argument.

The work is modest: one document that ties the room grade, airflow, material and personnel flows, the water system and the monitoring plan to the product risk. Most semi-solids plants already hold the pieces, scattered across SOPs and the HVAC design report.

Humiley uses the Annex 1 CCS as the organizing document on Life Sciences projects, so that airflow, flows, barriers, utilities, monitoring and qualification read as one argument.

Industries

Related

More on this subject

Performance Beyond the Surface

Cleanroom surfaces look like a finishing trade and behave like a performance system. Wall, floor and ceiling finishes decide whether a room can be cleaned to its classification, how long it survives a sporicidal regime, and how much particulate it sheds back into the air it was built to keep clean.

InsightRead

Both states are required; only the stage is a choice

A 50 m² Grade B room needs 10 classification locations under ISO 14644-1:2015, and EU GMP Annex 1 requires them at rest against ISO 5 and in operation against ISO 7, with the smoke study in both states. Whether each run sits in OQ or PQ is for the URS and risk assessment to justify.

InsightRead

Set a device assembly room's class from the product's risk

ISO 13485 §6.4.2 asks for documented contamination control without naming a cleanroom class. Setting the class from sterilisation method, patient contact and bioburden sensitivity often lands device assembly at ISO 8, with ISO 7 only where needed, less air than Grade C, a smaller AHU and a reason an auditor can read.

InsightRead