EU GMP Annex 15 asks for transport of finished products, investigational products and samples to be verified per route, seasons included. The plan is usually sound; the gap is the logger nobody checks before release. Name one role that downloads each logger on time, checks it against limits and can hold the stock.
21 CFR 11.10(e) says record changes shall not obscure previously recorded information. A SCADA log that stores only the new setpoint fails on that phrase. Three tests before OQ: read the trail after a change, try to edit it as administrator, and compare its retention with the batch records.
The CTD has five modules, and Module 3 (Quality) records the process, its controls and often the facility, including room grades, water grades and the conditions behind hold times. After approval, changing them generally needs a variation. Draft Module 3 and the design basis from one table and send every change to both teams.
The scope of EU GMP Annex 1 (2022) says some of its principles, including the contamination control strategy, may be used for certain non-sterile products such as liquids, creams and ointments. A semi-solids plant that writes a CCS tying room grades, flows, water and monitoring to product risk has an answer for the inspector.
When the HVAC load calculation assumes four operators and the aseptic process simulation qualifies six, the room runs outside its design basis. Write one maximum occupancy per room in the URS and carry it into the load calculation, room data sheet, APS protocol and entry SOP.
A reviewer cannot tell whether an empty box in an executed protocol was not applicable, forgotten or left to be filled in later. Close each unused field with N/A, initials and date at the time of execution, strike through unused pages, and have the reviewer return any blank.
EU GMP Annex 15 gives packaging validation two paragraphs (section 7 of the 2015 text). Packaging equipment should be qualified, and primary packing equipment at the minimum and maximum operating ranges of its critical parameters, such as temperature, machine speed and sealing pressure. The qualified range belongs to a format, so a new pack size reopens it.
Replacing a failed part is a correction. Corrective action removes the cause so the failure does not recur, and preventive action removes the cause of a failure that has not happened yet. Each needs an owner, a date and a check that it worked; ICH Q10 and EU GMP Chapter 1 expect the effectiveness of the actions to be evaluated.
In ISO and IEC standards, shall states a requirement, should a recommendation, may a permission and can a possibility. Normative annexes bind; nothing in an informative annex, a note or an example has to be met to claim conformity. EU GMP is different: it is written in 'should' and still expected. Check the verb and the annex before quoting a clause.
'Same product, new box' brings new artwork and codes to control, a registration that may need stability data at other climatic conditions, possibly a new pack to qualify, and one more changeover in the weekly plan. Cost the SKU as a small project before a launch date is promised.
The 2011 text of Annex 11 (clause 5) says systems that exchange data electronically should include built-in checks for correct and secure entry and processing. On a BMS-to-EMS link we read that as status flags, a communication watchdog, end-to-end checks of units and time stamps, and a loss-of-communication test in the qualification.
A signature under 'read and understood' shows that reading happened. EU GMP Chapter 2 says training should be appropriate to the duties assigned and its practical effectiveness should be periodically assessed. Practical tasks need demonstration, supervised practice and an observed assessment, with SOPs sorted by risk to make that affordable.